GTX Grip

This is a very heavy duty adjustable clamp. The spring loaded padded jaws will mount most anywhere and can be tightened using the large round knob ...

The Spring loaded Adjustable clamp with 3 mounting points and stud adapters give you the option of accessory mounting almost anywhere. The strong a...

This coupler can be used on up to mount lights and other accessories on pipe girds up to 2” diameter and creates an extremely strong mount point. C...

This Grip Head can be mounted on a stand with its 5/8" socket. The holes in the grip head are used to mount arms, studs, and other accessories onto...

Not to be confused with low cost version, this is super-strong professional quality clamp designed for stage, film, & broadcast production.  Co...

This is a 34”, 3 section Single articulated arm with 5/8” studs on each end. The arm can be configured in almost any direction using the main cente...

Umbrella/Stand mount with Coldshoe Speedlight mount. This Bracket has a 5/8” socket for stand mounting and an 8mm hole to insert your umbrella. It ...

Wall plates are a great way to place a light head or any other accessory almost anywhere. Clamp or screw them (using the pre-drilled holes) to most...

This 2” wide padded Jaw clamp can be attached to beams, tables, pipes, etc. Each Jaw Clamp includes a 5/8” stud to mount accessories. The bold thre...

This 4 ½” Grip head with a Junior Stud and receiver is designed to convert a Junior Stand into an overhead stand. It will allow the use of Junior a...

This is a 33”, 3 section Single articulated arm with 5/8” studs on each end. The arm can be configured in almost any direction using the main cente...

3” Spring clamp with 1 1/2” pipe clamp parallel to clamp.  The 3” jaws have rubber protective covers and will open to 2”.  The 3” jaws have rubber ...

3” Spring Clamp with 5/8” stud and ¼” x 20 male thread.  The 3” jaws have rubber protective covers and will open to 2”.

This is a 24” 2 section Single articulated arm with 5/8” studs on each end. The arm can be configured in almost any direction using the main center...

This 22” Flex arm has a 18mm diameter with brass studs on each end. One end has a 5/8” Hex stud with a female threaded 3/8” female mount. The other...

This Grip Head can be mounted on a stand with its 5/8" socket. The holes in the grip head are used to mount arms, studs, and other accessories onto...

This 4 ½” Grip head with a Junior Stud and receiver is designed to convert a Junior Stand into an overhead stand. It will allow the use of Junior a...

Attach to edge of cheese plate for adapting 15mm rods.